How to power on your Rhino device

T8/C10

Power on your device by holding the power button on the top left of the unit. The button should be pressed for 2-3s in order for it to boot.

T5se / R6

Power on your device by holding the power button on the right hand side of the unit. The button should be pressed for 2-3s in order for it to boot.

T6p

Power on your device by holding the power button on the left hand side of the unit. The button should be pressed for 2-3s in order for it to boot.

M10p / K27p

Locate the physical power switch on the back of the unit and switch it to the on position. Note there is no battery in this unit, so it must be connected to a permanent power source in order for the unit to power on.

NB: It is not supported by the unit to be powered down with the respective power keys (separate from the switches) and remain off. These units are designed to boot automatically when external power is detected and the power switches are in the on position.

DS

The unit will automatically boot when connected to a power source.

Applies to:

C10
C10
T8
T8
T5se
T5se
M10p
M10p
K27p
K27p
Download as PDF Report Content Print